Product Features:
- Non-alum, polymeric cationic coagulant.
- Concentrated.
- Safe for all pool types.
- The greater the amount of debris in the water, the faster Power Floc works.
Benefits:
- Makes water clear and sparkling.
- Settles suspended particles to the bottom for removal by vacuum.
- Works three times faster than previous flocculants like Liqui-Floc.
- Treats twice the water than the previous flocculants.
Application Instructions – Sand Filters:
- Shake well before using.
- Clean skimmer, hair and lint pot, and backwash and/or chemically clean filter. CAUTION: Under no circumstances should the filter pressure be allowed to exceed the value recommended by the filter manufacturer.
- Adjust pH to 7.5 to 8.0 for best results.
- Remove skimmer basket and any products (e.g. Smart Sticks) from skimmer.
- Apply at a rate of 60 mL per 10,000 litres. For extremely cloudy pools (can’t see the bottom of the deep end) use 120 mL per 10,000 litres.
- With pump on and filter valve in “Recirculate” or “Whirlpool” position, slowly pour required amount of Power Floc into skimmer.
- For filters without these settings, adjust to “Filter” position, dilute Power Floc into large plastic bucket (Do not exceed 60 mL of Power Floc in 4 litres of water), then pour evenly across surface of pool water.
- Replace skimmer basket and allow pump to circulate water for 1 – 2 hours to distribute Power Floc evenly throughout pool.
- Shut pump off and allow Power Floc to settle particulate matter for 12 – 24 hours. Do not disturb pool water during this time.
- Slowly vacuum settled material directly to waste. CAUTION: Do not vacuum debris through filter. As settling may continue over several days, repeat vacuuming where necessary.
- Backwash and chemically clean filter with Filter Brite, then reset to normal filter cycle.
- Adjust pH to 7.4 – 7.6 and resume normal pool operation.
Application Instructions – Cartridge Filters:
- Remove cartridge filter element from filter tank.
- Reassemble filter tank without filter element.
- With pump on, slowly pour required amount of Power Floc into skimmer.
- After adding Power Floc, allow pump to circulate for 1 – 2 hours.
- Shut pump off and allow Power Floc to settle particulate matter for 12 – 24 hours. Do not disturb pool water during this time.
- Slowly vacuum settled material directly to waste. CAUTION: Do not vacuum debris through filter. As settling may continue over several days, repeat vacuuming where necessary.
- Backwash and chemically clean filter with Filter Brite, then reset to normal filter cycle.
- Adjust pH to 7.4 – 7.6 and resume normal pool operation.
Application Instructions – Water with Algae:
- Power Floc will not kill algae but facilitates the removal of dead algae after treatment. BioGuard has a number of specific algae treatments. Follow the directions on the product you choose to treat algae.
- After the algae treatment is complete per the algaecide label directions, follow Application Instructions for Power Floc (see above).
Available Sizes:
- 1-litre bottles
NOTE: Avoid physical contact with product. Follow safety information on label Instructions. Store in a cool, dark place. Keep out of the reach of children.
